Unplanned
Last Updated: 11 Jun 2018 13:59 by ADMIN
wu
Created on: 04 Feb 2018 10:31
Category: UI for WPF
Type: Bug Report
1
Docking: When move the float window, the mouse point offset grows in steps when DPI is above 100%
maybe there are some ways to appear the  mouse point offset grow in steps when move the float window in raddocking by mouse drag.but I found when move the float window's header pass the document's tab,don't docking,then release mouse,and then move the float window again back and forth or up and down,the  mouse point offset grow in steps, at last the mouse's point leave the float window's header with hold the window's drag state.
Attached Files:
6 comments
ADMIN
Kalin
Posted on: 28 Mar 2018 11:08
Thanks for your feedback - the item is approved. Please follow it in order to get notified for status changes.
wu
Posted on: 17 Mar 2018 14:00
maybe it is the dpi problem too,the ToolWindow's resize response width is very small ,the corner resize is hard.
wu
Posted on: 17 Mar 2018 13:21
My windows10's DPI is 175%,I set to the 100%,and must restart the computer,then test the 
radwindow's drag,it is OK.
     So...yes,the DPI effect the dragging,maybe you should think about the higher DPI.
ADMIN
Kalin
Posted on: 16 Mar 2018 09:40
Hi Wu,

Thank you for contacting us. Indeed there is such issue when dragging ToolWindow/RadWindow on machines with DPI higher than 100%. Can you please let me know what is the DPI of your machine? If higher than 100% can you please test with 100% and let me know if the same behavior can be observed?

I'm looking forward to hearing from you.

Kalin
wu
Posted on: 22 Feb 2018 08:07
I found the any radwindow will appear the up problem!
wu
Posted on: 04 Feb 2018 10:39
Ok,I found when drag the docking's document to become the float window,and then move
the float window by a large margin,the up problem appear,my screeen is 2K/14 inch/Windows 10