Provide option for configuring the measurement units (centimeters [cm], inches [in]) used throughout RadRichTextBox UI, including:
- Ruler (currently supported and configurable through DocumentRuler.MeasurementUnit property which is of type UnitTypes)
- Table dialogs - for indents, widths and heights
- Paragraph indentation (currently shown only in points [pts])
- Section properties - header from top and footer from bottom
- Page setup - columns width in Columns dialog
- Page Margins and Page Size in Ribbon UI

Currently parts of the dialogs and controls shows measures in pixels (actually DIPs), other in inches (e.g. ruler).